The 3c2 error code on Samsung washers indicates that there is a problem with the door sensor. This sensor is located on the door of the washer and is responsible for detecting when the door is closed. If the door sensor is not working properly, it will not be able to detect when the door is closed, and the washer will not start. There are a few things that can cause the door sensor to fail, such as a loose connection or a defective sensor.
- Check the door sensor and make sure it is clean and free of debris
- Check the water inlet valves and make sure they are turned on and supplying water to the washer
- Clean the drain pump filter and make sure there is no blockage preventing the water from draining from the washer
- Replace the door sensor if it is damaged or not functioning properly
- Replace the water inlet valves if they are damaged or not functioning properly
- Replace the drain pump if it is damaged or not functioning properly
1. Check the door sensor and make sure it is clean and free of debris
- Open the door of the washer and look for any debris or obstructions on the door sensor. If there is anything on the sensor, use a vacuum cleaner to remove it.
- Look for any water spots or stains on the door sensor. If there are any, use a cleaner to clean them away.
- Check to see if the door sensor is working properly by opening and closing the door several times. If the sensor is not working properly, you will need to replace it.
2. Check the water inlet valves and make sure they are turned on and supplying water to the washer
1 Open the front cover of the washer. 2 Turn the water inlet valves to the "on" position. 3 Make sure the water is flowing through the water inlet valves. 4 If the water inlet valves are not turning on or the water is not flowing through them, check the fuses or circuit breaker.
3. Clean the drain pump filter and make sure there is no blockage preventing the water from draining from the washer
- Turn off the washer and disconnect the water supply.
- Remove the drain pump filter by unscrewing the retaining screws.
- If there is a blockage, clear it using a plunger or a vacuum cleaner.
- Replace the filter and reattach the retaining screws.
- Reconnect the water supply and turn on the washer. If the washer still does not drain, it may be necessary to replace the water pump.
4. Replace the door sensor if it is damaged or not functioning properly
If the door sensor is damaged or not functioning properly, the first step is to replace it. To do this, remove the front panel of the washer by removing the six screws that hold it in place. Once the panel is removed, access the door sensor by removing the two screws that hold it in place. Once the sensor is removed, replace it with a new one by following the instructions that come with the new sensor. It is also possible to fix 3c2 error code samsung washer by replacing the door switch. To do this, remove the screws that hold the switch in place and replace it with a new one.
5. Replace the water inlet valves if they are damaged or not functioning properly
To replace the water inlet valves on a Samsung washer, you'll need a screwdriver, a wrench, and a pair of pliers.1. Shut off the water supply to the washer.2. Remove the screws that hold the water inlet valves in place.3. Lift the water inlet valves out of the washer.4. Replace the water inlet valves with new ones.5. Reinstall the screws and water inlet valves.6. Turn on the water supply to the washer.7. Check to see if the washer is now washing properly.
6. Replace the drain pump if it is damaged or not functioning properly
- Remove the door panel.
- Remove the screws that hold the pump in place.
- Remove the pump.
- Clean the area around the pump with a solvent and a brush.
- Place the new pump in the same location.
- Replace the screws.
- Replace the door panel.