Exit code 137 is a generic error code that indicates that a process has been killed by a signal. This can happen for a variety of reasons, but most commonly it occurs when a process is trying to access a resource that it does not have permission to.
People like you are also looking for:
- 137 error code
- error command failed with exit code 137.
- exit code 137
1. Check for any errors in the code
- Check for any errors in the code.
- Fix any errors found.
- Test the code to ensure that it works as intended.
2. Run the code in a debugger
- Open the file in a text editor and locate the line of code that causes the error.
- If the line of code is inside a function, stop execution at the function call and use the debugger to examine the code inside the function.
- If the line of code is outside a function, stop execution at the first line after the code that causes the error.
- Use the debugger to examine the code that causes the error.
- If the code that causes the error is inside a function, use the debugger to examine the function call that caused the error.
- If the code that causes the error is outside a function, use the debugger to examine the line of code that causes the error.
- Use the debugger to figure out what is causing the error and fix it.
3. Try to run the code on a different machine
There is not a definitive answer to this question as it depends on the specific code and the operating system on which it is being run. However, some general guidance on how to try to fix an exit code of 137 on a different machine might include checking the machine's system requirements and trying to run the code using a different version of the programming language or operating system. Additionally, it may be helpful to consult online resources or ask other software engineers for advice.
If the answers above didn't work then you should also try:
- Check for memory leaks.
- Try to increase the memory available to the program.
- Try to recompile the code.
- Try to use a different compiler.