The F1 code on a Whirlpool Cabrio washer indicates that there is a problem with the washer's control board. This error code can be caused by a number of things, including a power surge, a faulty control board, or a problem with the washer's wiring.
You are here because you have a question about:
- whirlpool cabrio f1 error code
- whirlpool cabrio error code f1
- whirlpool washer f1 error code
- f1 code on whirlpool cabrio washer
1. Check the wash cycle settings
- Open the machine by pressing the release button.
- Look for the "Wash Cycle" control panel on the machine.
- Look for the "Wash Cycle" selector switch and turn it to the "Delayed" position.
- Check the "Delay Start Time" setting. This should be set to "0".
- Check the "Delay End Time" setting. This should be set to "24".
- Check the "Selective Wash" setting. This should be set to "Off".
- Check the "Rinse" setting. This should be set to "Off".
- Close the machine by pressing the release button.
2. Check the water temperature settings
- Remove the water tank from the whirlpool cabrio washer.
- Check the water temperature setting.
- If the water temperature is incorrect, set the water temperature to the correct value and replace the water tank.
- Reconnect the water line to the whirlpool cabrio washer.
- Test the whirlpool cabrio washer.
3. Check the water level settings
- Verify that the water level is set to the proper level in the washer tub.
- If the water level is not set to the proper level, adjust the water level so that the washer tub is at the proper level.
- If the water level is still not set to the proper level, replace the water level sensor.
If you didn't find success with an option above, then try:
- Check the detergent dispenser.
- Clean the washer tub.
- Clean the washer filters.
- Clean the washer drain.
- Inspect the washer hoses.
- Replace the washer lid switch.
- Replace the washer motor.