How do I fix an F1 error code on a Whirlpool washer?

The F1 code on a Whirlpool washer indicates that there is a problem with the washer's control board. This error code can happen for a number of reasons, such as a power surge or a problem with the control board itself. If the F1 code appears, the washer will not start.

Users typically search for a solution by asking about:

• f1 error code whirlpool washer
• f1 code on whirlpool washer

• Check the wiring to the washer
• Check the washer's water supply
• Check the washer's drain
• Check the washer's door seal

1. Check the wiring to the washer

1. Verify that the power is off to the washer.
2. Remove the top cover of the washer.
3. Verify that all the wires going into the washer are plugged in and properly connected.
4. If there is a problem with one of the wiring connections, replace the wiring connection.
5. Replace the top cover of the washer.

2. Check the washer's water supply

1. Check to see if the water supply to the washer is shut off. If it is, turn off the water supply to the washer.
2. If the washer has a water filter, remove it and clean the filter.
3. If the washer has a water filter, check to see if the filter is clogged. If it is, clean the filter.
4. If the washer has a water filter, check to see if the filter is in good condition. If it is not, replace the filter.
5. If the washer has a water filter, check to see if the water supply to the washer is turned on. If it is not, turn on the water supply to the washer.
6. Check to see if the water supply to the washer is turned off at the water source. If it is not, turn off the water supply to the washer.
7. Check to see if the water supply to the washer is turned on at the water source. If it is not, turn on the water supply to the washer.
8. Check to see if the water in the tub is cold. If it is not, turn on the water supply to the washer and wait until the tub is cold before starting.
9. Check to see if the washer is filling with water. If it is not, turn on the water supply to the washer and wait until the washer is filling with water.
10. If the washer still does not work, call a professional to fix the f1 code on your whirlpool washer.

3. Check the washer's drain

1. Check the water level in the washer. If it is low, add water.
2. Open the front panel of the washer.
3. Check the water flow from the drain. If it is low, add water.
4. Check the washer drain hose for obstructions. If there are obstructions, remove them.
5. Check the washer drain for clogs. If there are clogs, remove them.
6. Check the washer drain for leaks. If there are leaks, fix them.

4. Check the washer's door seal

1. Remove the screws that hold the door on.
2. Lift the door off of the hinges.
3. Check the condition of the seal on the door. If it is damaged, replace the seal.
4. Reinstall the door onto the hinges, making sure that the seal is in the correct position.
5. Replace the screws that hold the door on.

Some users might also have success with the following opitons:

1. Check the washer's drive belt.