The Whirlpool washer f02 code is an error code that indicates that the washer is not draining properly. This error code can happen for a number of reasons, such as a clogged drain hose or a problem with the drain pump. If you see this error code, you should check the drain hose to make sure it is not clogged, and then check the drain pump to make sure it is working properly.
Other common searches for this error include:
- f02 error code whirlpool washer
- whirlpool duet washer f02 error code
- whirlpool washer f02 code
1. Check for and clear any clogs in the washer's drain hose or in the home's drainpipes
- Locate the washer's drain hose. If it is clogged, use a plunger to push the clog out of the drain. If the drain is at the washer, use a bucket to catch the water that drains out.
- If the drain is at the home's plumbing, use a flashlight to inspect the pipes for clogs. If there are any, use a plunger to clear them.
2. Check that the washer's water supply valves are fully open
- Check the water supply valves to the washer are fully open by using a water inspection tool.
- If the valves are not fully open, close them using a wrench.
- Replace the washer water supply hose if needed.
- Replace the washer water supply valve if needed.
3. Replace the washer's drain pump if it is defective
If the washer's drain pump is defective, the first step is to remove the washer from the wall outlet. Next, locate the drain pump on the bottom of the washer. To replace the pump, remove the four screws that hold it in place and remove the pump.
Still not working? maybe try one of these options:
- Run a maintenance cycle to clean the washer's internal components.
- Contact Whirlpool for further assistance.