Maytag washer error codes indicate a problem with the washing machine. The code may indicate that the washing machine is not draining properly, the water level is too low, or the washer is not spinning. There may be other reasons for the error code, but these are the most common. If the error code is not resolved, it may cause the washing machine to stop working altogether.
Users typically search for a solution by asking about:
- how to reset error code on maytag washer
- maytag error code
- maytag washer error code
- maytag washer error codes
1. Check the inlet hoses to ensure they are not kinked or clogged
- Open the front cover of the washer.
- Inspect the inlet hoses for kinks or obstructions.
- If there are any obstructions or kinks, use a hose clamp to fix them.
- Reconnect the inlet hoses.
- Close the front cover of the washer.
- Check the washer error codes.
2. Clean the inlet hose screens
- Turn off the water supply to the washer.
- Remove the front panel of the washer.
- Remove the inlet hose.
- Clean the inlet hose screens.
- Reinstall the inlet hose.
- Reconnect the water supply to the washer.
- Turn on the water supply to the washer.
3. Inspect the drain hose for kinks or clogs
- Remove the front panel of the washer.
- Look for any obstructions in the drain hose.
- Inspect the drain hose for kinks or clogs. If there are any, fix them using a pipe wrench.
- Reinstall the front panel and test the washer.
4. Clean the drain pump filter
If the drain pump filter is dirty, the washing machine will give a code indicating the filter is not clean. To clean the filter, remove the front panel of the washer and remove the filter. Wash the filter in a large enough container of water with a mild detergent. After washing, rinse the filter and replace the front panel of the washer.
If the answers above didn't work then you should also try:
- Run a diagnostic test to identify the specific error code.
- Replace any damaged parts.