When a Nikon camera detects an error, it displays a blinking error code in the viewfinder. There are many different error codes that can be displayed, but the most common are:
• Err - This error code indicates that the camera has detected an error and is unable to continue functioning.
• FEE - This error code indicates that the camera's lens is not properly attached or that the aperture ring is not set to the minimum aperture.
• CHA - This error code indicates that there is a problem with the camera's memory card.
• FOR - This error code indicates that the camera's shutter is not working properly.
• LEE - This error code indicates that the camera's image sensor is not working properly.
• D1 - This error code indicates that the camera's shutter speed is too fast.
• D2 - This error code indicates that the camera's aperture is too small.
• D3 - This error code indicates that the camera's ISO is too high.
• D4 - This error code indicates that the camera's white balance is incorrect.
• D5 - This error code indicates that the camera's exposure compensation is incorrect.
• D6 - This error code indicates that the camera's flash is not working properly.
• D7 - This error code indicates that the camera's image is overexposed.
• D8 - This error code indicates that the camera's image is underexposed.
Nikon error codes can be caused by a variety of factors, including user error, camera malfunction, or simply a bad connection. If you see an error code on your camera, it is important to try to figure out what is causing the problem so that you can fix it and avoid future errors.
Users typically search for a solution by asking about:
- nikon error code
- nikon error codes
1. Try a different memory card
- Remove the battery and memory card from the camera.
- Turn off the camera.
- Remove the lens.
- Look for a card slot on the side of the camera.
- Insert the card that you want to use into the card slot.
- Replace the lens.
- Turn on the camera.
- Check to see if the error message has disappeared.
2. Try a different lens
- Remove the lens from the camera
- Check to see if the lens is properly seated in the camera body
- Check the lens' mounting screws for tightness
- Check the lens' aperture ring for proper operation
- Test the lens by taking a picture and reviewing the image on the camera display
- If the lens still fails to operate properly, remove the lens and take it to a service center
3. Clean the contacts on the camera and lens
First, remove the battery and memory card from the camera. Next, remove the lens. Finally, clean the contacts on the camera and lens with a cloth and rubbing alcohol.
If you didn't find success with an option above, then try:
- Update the firmware on the camera.
- Send the camera in for service.