The oe error code on a Samsung washing machine indicates a water drainage problem. This can be caused by a blockage in the drain hose or pump, or a problem with the water pressure in the home. Samsung washing machines are equipped with a self-diagnosing system that detects and diagnoses problems with the machine. If the oe error code is displayed, it means that the machine has detected a water drainage problem and is unable to continue the washing cycle.
You are here because you have a question about:
- oe error code samsung washer
- oe on samsung washer
1. Check the power supply to the washer
- Remove the water inlet hose.
- Remove the water outlet hose.
- Remove the electrical cord from the washer.
- Check the power supply to the washer to see if the power is off or if the power is on but the washer doesn't seem to be working.
- If the power supply to the washer is off, replace the power supply.
- If the power supply to the washer is on but the washer doesn't seem to be working, replace the washer power cord.
2. Check the water supply to the washer
- Check if the water valve is properly closed - if it's not closed properly, water can get into the machine and cause problems.
- Check the water pressure - if it's low, the washer can't get the water it needs to operate properly.
- Check the water lines - if they're leaking, water can get into the machine and cause problems.
- Check the water filter - if it's not working properly, water can get into the machine and cause problems.
3. Check the drain hose for blockages
There are a few different ways to check the drain hose for blockages. One way is to use a snake to clear the drain hose of any obstructions. Another way is to use a camera to inspect the drain hose for any blockages.
4. Clean the washer's filter
The first step in cleaning the washer's filter is to unplug the washer. Next, remove the water and detergent tanks by unscrewing the caps. Remove the filter by pulling it out from the back of the machine. Rinse the filter with clear water and let it dry. Replace the filter and screw the tank back on to the machine. Plug in the washer and turn it on. The washer should now work properly with a clean filter.
5. Run a maintenance cycle on the washer
-Check the water levels in the washer. If the water levels are too low, add water to the reservoir. If the water levels are too high, adjust the water levels in the reservoir. -Check the water temperature. If it is too hot, turn the water temperature down. If it is too cold, turn the water temperature up. -Check the washer for any clogs. If there are any clogs, clear them using a plunger. -Check the agitator to see if it is rotating. If it is not rotating, replace the agitator. -Check the drain hose to see if it is clogged. If it is clogged, clear it using a plunger. -Check the filters. If they are dirty, replace them.