The Whirlpool Duet F11 error code indicates that the washer is not draining properly. This can be caused by a clogged drain, a faulty drain pump, or a problem with the control board. The washer will not start if the F11 error code is displayed.
Users typically search for a solution by asking about:
- whirlpool duet washer f11 error code
- whirlpool duet f11 error codes
1. Check the wiring harnesses for the main control board and the motor control board
- Check the main control board wiring harness for continuity and proper connections.
- Check the motor control board wiring harness for continuity and proper connections.
- If either the main control board or motor control board wiring harness is damaged, replace the wiring harness.
2. Check the drain pump and pressure switch for proper operation
- Turn on the water supply to the whirlpool duet f11.
- Open the drain valve on the side of the machine that is not leaking.
- Turn on the water supply to the machine.
- Wait ten minutes for the machine to stabilize.
- Check the drain pump and pressure switch for proper operation. If the pressure switch is not operational, replace the pressure switch. If the drain pump is not operational, replace the drain pump.
3. Clean the drain pump filter and check the drain hose for clogs
- Turn off the water supply to the whirlpool duet f11.
- Remove the drain pump filter by unscrewing the two screws on the top of the filter.
- If the drain filter is dirty, clean it with a damp cloth or a vacuum cleaner.
- Check the drain hose for clogs by putting a finger down the drain hose and moving it up and down. If the drain hose is clogged, use a plunger to clear the obstruction.
- Replace the drain pump filter and screw the screws back in place.
- Turn on the water supply to the whirlpool duet f11 and check for water flow through the drain hose.
If the answers above didn't work then you should also try:
- Replace the main control board or the motor control board.