How do I fix an error code on my Frigidaire Dishwasher?

If your Frigidaire dishwasher is displaying the ER code, it means that there is an error with the water heating system. This can be caused by a variety of issues, such as a faulty heating element, a problem with the water inlet valve, or a blockage in the dishwasher’s drain line. You will need to troubleshoot the dishwasher to determine the cause of the ER code and fix the problem.

You are here because you have a question about:

• frigidaire dishwasher error code co
• frigidaire dishwasher er code

• Check the electrical panel to ensure that the dishwasher is receiving power
• Inspect the door gasket and door latch to make sure they are properly sealed and functioning
• Clean the dishwasher filters and spray arm to remove any food or grease build-up
• Run the dishwasher through a test cycle to see if the error code reappears
• If the error code persists, contact a Frigidaire service technician for further diagnosis and repair

1. Check the electrical panel to ensure that the dishwasher is receiving power

1. Look for a circuit breaker or fuse that may be blown. If there is a blown fuse, it may need to be replaced. If there is a circuit breaker, it may need to be reset.
2. Check the outlet that the dishwasher is plugged into to make sure that the power is being delivered. If the outlet is not working, the dishwasher may need to be replaced.
3. Check the dishwasher's power cord for any breaks or damage. If there are any breaks or damage, the dishwasher may need to be replaced.

2. Inspect the door gasket and door latch to make sure they are properly sealed and functioning

The steps to inspect the door gasket and door latch to make sure they are properly sealed and functioning in order to fix frigidaire dishwasher er code are as follows:

1. Inspect the door gasket for tears, leaks, or other signs of damage.
2. Check the door latch to make sure it is properly engaged and seals properly against the door panel.
3. If the door gasket or door latch are defective, replace them as needed.

3. Clean the dishwasher filters and spray arm to remove any food or grease build-up

The dishwasher filter must be replaced every 6 months, and the spray arm must be cleaned every 3 months. To clean the dishwasher filter, remove the filter by unscrewing the bottom of the dishwasher. Rinse the filter with water and screw it back on. To clean the spray arm, remove the spray arm by unscrewing the bottom of the dishwasher. Wipe it clean with a cloth dampened with dishwashing detergent.

4. Run the dishwasher through a test cycle to see if the error code reappears

To run the dishwasher through a test cycle, open the dishwasher door, and press the start/stop button. If the error code reappears, follow the steps below to fix the frigidaire dishwasher er code.

1. Verify that the dishwasher is plugged into an outlet and properly connected to the power source.
2. Verify that the dishwasher's water supply is properly connected and not frozen.
3. Verify that the dishwasher's drain hose is properly connected and not blocked.
4. Verify that the dishwasher's filter is properly installed and properly secured.
5. Verify that the dishwasher's door is properly closed and latched.
6. Verify that the dishwasher's water pressure is correct.
7. Verify that the dishwasher's spray arm is properly adjusted.
8. Verify that the dishwasher's heating element is properly installed and operational.
9. Verify that the dishwasher's water temperature is correct.
10. Verify that the dishwasher's detergent is properly loaded.

5. If the error code persists, contact a Frigidaire service technician for further diagnosis and repair

If the error code persists, contact a Frigidaire service technician for further diagnosis and repair.